Mono bass and mid/side: what to keep in the centre
Keep kick, bass and anything else below roughly 120 Hz in the centre. Stereo information that low is hard to hear as width and causes real problems: notes that vanish in mono, uneven bass between speakers, and wasted headroom.
Mid and side in one paragraph
Any stereo signal can be rewritten as two other signals. Mid is left plus right, halved: everything the two speakers have in common. Side is left minus right, halved: everything that differs. A sound panned dead centre is all mid. A sound in one speaker only is half mid and half side. Convert back and you have the original left and right. Mid/side processing means changing one of those signals, with EQ or level, before converting back.
Why low frequencies want to be mono
Mono playback. Phones, smart speakers, many club systems and most shop ceilings play in mono or close to it. Mono is the mid signal. Whatever low end lives in the side signal isn't played.
Cancellation. A bass with a stereo chorus or a wide synth patch has lows that differ in phase between left and right. Summed to mono, those partly cancel, and the bass drops several dB.
Subs. Most systems with a subwoofer have one, fed with a mono sum.
Headroom. Low frequencies carry the most energy. Out-of-phase lows use up level and limiter headroom and add nothing audible.
Vinyl. A cutting lathe turns side information into vertical groove movement. Too much of it at low frequencies makes the stylus jump.
Below about 100 Hz the ear is also poor at locating sound, so little is lost.
How to do it
| Situation | Approach |
|---|---|
| Kick and bass tracks | Pan centre. Record or bounce them mono |
| Stereo synth bass | High-pass the side signal at 120 Hz, or split it: mono sub layer, wide upper layer |
| Wide guitars and keys | High-pass them at 80 to 120 Hz. They don't need those lows |
| Stereo reverb | High-pass the reverb return at 200 to 300 Hz |
| Whole mix | A mid/side EQ on the master with a high-pass on the side channel at 100 to 120 Hz |
How to check
- Listen in mono. Sum the master to mono and compare the bass level with stereo. If it drops, something low is out of phase.
- Watch a correlation meter on the low end. It should sit near +1 below 120 Hz. See stereo width and correlation.
- Solo one speaker. The bass should be the same level in left and right.
Width belongs higher up
Stereo interest comes from the midrange and treble: doubled guitars, backing vocals, reverb, hi-hats and percussion. A mix with solid mono lows and wide content above 300 Hz sounds bigger than one that's wide everywhere, and it survives every playback system.
Quick answers
- What frequency should bass be mono below?
- 100 to 150 Hz is the usual range, with 120 Hz a common choice. Club and vinyl masters sometimes go as high as 200 Hz.
- What is mid/side?
- A way of describing stereo as a sum and a difference. Mid is what the left and right channels share; side is what differs between them.
Audizer does this when you ask.A Mac DAW with an engineer built in. Say what you want and it makes the edit. Free download.
Get Audizer