Audizer
Mixing

How to blend a bass DI with an amp sim

Put the DI on two tracks. Leave one clean and low-pass it around 200 to 300 Hz for the fundamentals. Run the other through an amp simulator and high-pass it around 150 to 250 Hz for the growl. Make sure they're time-aligned, compress the clean one harder, and blend the amp track in until the bass is audible on small speakers.

Why split it

A bass amp and cabinet add harmonics and character, and they also change the low end: speakers roll off, distortion compresses unevenly, and the bottom gets looser. A DI has perfect lows and a plain, slightly clanky midrange.

Splitting gives you the best of each. The clean track does one job, holding 40 to 200 Hz steady. The amp track does another, supplying 200 Hz to 3 kHz of harmonics. Neither can spoil the other's range.

The steps

  1. Duplicate the DI to a second track.
  2. Clean track: low-pass at 200 to 300 Hz with a 12 dB slope. Compress at 4:1 with 30 ms attack, 150 ms release, 5 to 8 dB of reduction. This is the foundation.
  3. Amp track: insert the amp simulator. Set gain for a little break-up on hard notes. High-pass after it at 150 to 250 Hz.
  4. Check polarity. Play both and flip the polarity of the amp track. Keep whichever position has more low-mid weight around the crossover.
  5. Check timing. Zoom in on a note's start. If the amp track is late by more than a fraction of a millisecond, slide it earlier until the first peaks line up.
  6. Blend. Clean track up first to set the low end against the kick. Then raise the amp track until the bass line is clear on small speakers or headphones.
  7. Bus them together, and put any final EQ or light compression on the bus so both layers move as one.

Amp settings that work

ControlStarting point
Gain or driveUntil the meter or your ear shows slight break-up on loud notes
Bass12 o'clock or lower. The clean track handles lows
MidSlightly up. 500 to 800 Hz is where bass cuts through guitars
TrebleTo taste. 2 to 3 kHz adds string and pick definition
CabinetOn. An amp with no cabinet has harsh fizz above 5 kHz

If the simulator has no cabinet section, low-pass the amp track at 4 to 5 kHz.

Variations

  • Heavy rock and metal: more gain on the amp track, high-pass it higher at 300 to 400 Hz, and consider a third, heavily distorted layer high-passed at 800 Hz.
  • Pop and R&B: very little amp, or replace it with gentle tube-style saturation.
  • One track only: if you can't duplicate, use a saturator with a mix control at 30 to 50%. You lose the separate filtering and it still helps.

Check the result

Solo the blend and sweep through the song. Low notes should stay equally loud from the lowest to the highest. Then listen on a phone speaker. If you can follow the bass line there, the amp layer is doing its job.

Quick answers

Should I use a DI or an amp sim for bass?
Both. The DI gives a solid, consistent low end. The amp gives harmonics that let the bass be heard on small speakers. Blend them.
Why does my bass get thinner when I blend DI and amp?
The two are out of time or out of polarity. Flip the polarity of one, and if that doesn't fix it, slide one track until the waveforms line up.

Audizer does this when you ask.A Mac DAW with an engineer built in. Say what you want and it makes the edit. Free download.

Get Audizer

Updated 2026-11-15. Corrections: support@intuzu.com