Saturation: what it does and when to use it
Saturation is gentle distortion. It adds harmonics above the notes already there and squashes the highest peaks, which makes a sound denser, easier to hear on small speakers and a little more controlled. Use enough to notice when you bypass it and no more.
What's happening
Push a signal into tape, a valve or a transformer and the tops of the waveform get rounded instead of reproduced exactly. That rounding creates new frequencies at multiples of the original. A 100 Hz bass note gains energy at 200, 300, 400 Hz and up.
Two useful things follow. The peaks are lower, so the track takes less headroom for the same loudness. And the sound now has content in ranges where it had none, so a bass that vanished on a phone speaker can be heard through its harmonics.
Types
| Type | Harmonics | Character | Good on |
|---|---|---|---|
| Tape | Mostly odd, with softened highs and a low-end bump | Smooth, rounded, slightly compressed | Drums, mix bus, anything too sharp |
| Tube | Even and odd, strong 2nd | Warm, thick, forward | Vocals, bass, keys |
| Transformer | Low-order, mostly in the lows | Weight and solidity | Kick, bass |
| Soft clip | Odd | Transparent until pushed | Drum bus, taming peaks before a limiter |
| Hard clip | Odd, extending high | Aggressive, bright | Snare and kick peaks, in small amounts |
| Fuzz | Dense, both | Obvious effect | Guitars, synths, special effects |
Even harmonics are octaves and fifths of the original note and blend in as warmth. Odd harmonics add edge.
Where it earns its place
Bass. The most valuable use. Harmonics at 200 to 800 Hz make the line audible on speakers that can't reproduce the fundamental. Start with tube-style drive and a 30 to 50% mix.
Vocals. A little drive adds density and helps a vocal hold its place without more level. If you can hear fuzz on sustained notes, it's too much.
Drums. Tape-style saturation rounds off the sharpest transients, which lets the drum bus run louder before the limiter reacts. Clipping the top 2 to 3 dB off snare peaks does the same more bluntly.
Sterile synths and DI instruments. Anything recorded direct can lack the harmonic complexity that a microphone, amplifier and room add.
Mix bus. Very light. On a full mix, saturation creates intermodulation between every instrument and gets muddy fast.
How to set it
- Turn the drive up until you clearly hear distortion.
- Back off until it disappears as an effect.
- Match the output level to bypass. Saturation makes things louder, and louder fools you every time.
- Toggle bypass in the full mix. It should sound a bit fuller and steadier with it in.
- If the plugin has a mix control, try heavier drive blended at 20 to 40%.
When it hurts
Saturation on many tracks adds up. Each one contributes harmonics in the 2 to 6 kHz range, and the mix turns harsh and congested without any single track sounding distorted. If a mix is tiring to listen to and you've saturated a dozen tracks, bypass them all and bring back two.
It also raises the noise floor, since drive is gain.
Quick answers
- What is the difference between saturation and distortion?
- They are the same process at different amounts. Saturation is distortion mild enough to be heard as warmth or thickness rather than as fuzz.
- Does saturation make a track louder?
- It raises perceived loudness for the same peak level, because it rounds off peaks and adds harmonics. Always match levels before judging it.
Audizer does this when you ask.A Mac DAW with an engineer built in. Say what you want and it makes the edit. Free download.
Get Audizer