How to clean up a vocal take, step by step
Work in this order: cut the silence between phrases, put a short fade on every cut, reduce steady noise only if you can hear it, level the phrases against each other, then tune. Do all of it before any compressor or reverb goes on.
A raw vocal track is mostly silence with headphone bleed, chair creaks and breathing in it. Once you compress that track by 6 dB, all of it comes up 6 dB. Cleaning first is cheaper than fixing it later.
The steps
- Listen to the whole take solo, once. Note clicks, bumped stands, coughs and any word you'll need to replace. Don't fix anything yet.
- Cut the gaps. Remove everything between phrases that isn't performance. Use a threshold around −45 dB, only cut gaps longer than about 350 ms, and leave 50 to 100 ms of padding before each phrase so breaths and soft consonants survive. See strip silence settings.
- Fade every edge. 5 to 20 ms in, 20 to 60 ms out. A cut with no fade can click, even in a quiet passage.
- Decide about breaths. Keep the ones that belong to the phrasing and pull the loud ones down 6 to 10 dB with clip gain. Delete only gasps that distract.
- Reduce noise if it's audible. For steady hiss or room tone, 6 to 12 dB of reduction is plenty. More than that starts to dull the voice. Removing background noise has the detail.
- Tame plosives and thumps. A high-pass at 80 to 100 Hz handles most of them. For a single "p" that still pops, cut it out as its own clip and drop its gain 6 dB, or fade its first 20 ms.
- Level the phrases. Bring quiet lines up and loud ones down with clip gain until they sit within 3 to 4 dB of each other. Why this comes before compression.
- Tune. Now that the take is clean and even, pitch detection has the best chance of reading it correctly.
How long this takes
By hand, a 3-minute lead vocal is 30 to 60 minutes of careful work, and each double or harmony is the same again. It's the part of a session people skip, and the part that most separates a demo from a finished vocal.
Check your work
Solo the cleaned track and listen on headphones at a higher level than you'd mix at. You're listening for chopped word endings, clicks at edits and breaths that vanish abruptly. Then un-solo it. If the vocal sounds drier and closer, the clean-up worked.
Quick answers
- Should I remove breaths from a vocal?
- Turn them down 6 to 10 dB and keep them. A vocal with every breath deleted sounds unnatural, especially in sparse arrangements.
- Do I edit before or after compression?
- Before. Compression raises breaths, noise and room tone, so clean the take first.
Audizer does this when you ask.A Mac DAW with an engineer built in. Say what you want and it makes the edit. Free download.
Get Audizer