How to remove background noise from a recording
For steady noise such as hiss, a fan or room tone, cut the silent gaps first, add a high-pass filter, and then apply 6 to 12 dB of broadband noise reduction. Stop when you hear the voice or instrument start to change. Sudden noises like clicks, traffic and a dog barking need editing, not noise reduction.
Work out what kind of noise it is
| Noise | Sounds like | Best tool |
|---|---|---|
| Hiss, preamp noise | Steady "shhh", mostly above 2 kHz | Broadband noise reduction |
| Fan, air conditioning, room tone | Steady whoosh and rumble | High-pass filter, then noise reduction |
| Mains hum | A low note at 50 or 60 Hz with a buzz on top | Narrow notches. See removing hum |
| Clicks, bumps, chair creaks | Short and irregular | Cut them out or lower clip gain |
| Bleed from headphones or other instruments | Music | A gate or strip silence between phrases; nothing removes it under the performance |
The order that gets the most for the least damage
- Cut the gaps. Noise is most audible when nothing else is playing. Removing the silence between phrases often solves the problem on its own.
- High-pass. Much of room noise is below 100 Hz, where a vocal or guitar has nothing useful. Filter it.
- Apply noise reduction lightly. Start at a moderate amount and listen to a quiet passage with a held note. Raise it until the noise stops bothering you, then back off a step.
- Check the tails. Reverb tails, breaths and soft word endings are the first things noise reduction eats. If they sound gated or metallic, use less.
- Compare at mix level. Noise that's obvious in solo at high volume may be inaudible once the band is in. Stop when it's inaudible in context.
How these tools work, and why they fail
Most noise reducers split the sound into hundreds of narrow frequency bands and turn down each band whenever it falls to the level of the measured noise. With a small reduction the bands close gently and you hear less noise. With a large one, bands flick open and shut at random and you hear a chirping or watery texture, sometimes called musical noise.
That's why moderate settings beat aggressive ones, and why a 10 dB improvement that sounds natural is worth more than 25 dB that sounds processed.
Prevention is cheaper
- Record 15 to 20 cm from the mic, not 60. Halving the distance raises the voice about 6 dB over the room.
- Turn off fans, fridges and the laptop's noisy apps for the take.
- Set preamp gain so peaks reach −12 to −6 dBFS. Recording too quietly and boosting later raises converter and preamp noise with it.
- Record 5 seconds of room tone before each take. It's useful for patching edits.
Quick answers
- How much noise reduction is too much?
- Past about 12 dB most tools start to produce chirpy, underwater artefacts and dull the source. 6 to 12 dB is the useful range.
- Should noise reduction come before or after compression?
- Before. A compressor with 6 dB of makeup gain raises the noise by 6 dB, and the reduction tool then has to work harder on a changing noise floor.
Audizer does this when you ask.A Mac DAW with an engineer built in. Say what you want and it makes the edit. Free download.
Get Audizer