Noise floor: what it is and what's acceptable
The noise floor is the level of the hiss, hum and room sound left when the performer stops. Measure it as the RMS level of a silent gap. For a home vocal recording, −60 dBFS or lower is clean, −50 is workable, and above −45 it becomes audible after compression.
Where it comes from
- The room: computer fans, traffic, air handling, the fridge two rooms away. This is usually the largest part.
- The preamp: hiss that rises as you turn up the gain. Quiet sources into low-output microphones need the most gain and get the most hiss.
- Interference: mains hum, phone and Wi-Fi chatter, a noisy USB port.
- The converter: far below the others on any modern interface.
What matters is the gap, not the absolute number
Signal-to-noise ratio is the distance between the performance and the floor. A vocal averaging −18 dBFS over a −60 dBFS floor has 42 dB of separation. That's the figure that decides whether you'll hear noise in the finished mix.
| Separation | In practice |
|---|---|
| 50 dB or more | Inaudible in any mix |
| 40 to 50 dB | Clean. Fine for exposed vocals |
| 30 to 40 dB | Audible in quiet passages after compression |
| Under 30 dB | Obvious. Needs treatment or a retake |
How processing moves it
Every stage that adds gain lifts the floor.
- Compression with 6 dB of makeup gain reduces the separation by 6 dB.
- A high shelf of +3 dB at 10 kHz raises hiss by 3 dB.
- Limiting on the master to raise loudness 8 dB brings up the noise of every track 8 dB.
- Stacking tracks adds noise too. 8 similar tracks sum to a floor about 9 dB higher than one.
A vocal that was fine raw at −55 dBFS can end up with its noise at −38 dBFS in the master. That's why clean-up happens early. See how to clean up a vocal take.
Filtering can move the reading too. A high-pass removes low-frequency energy and can reveal a floor that the low end was masking, so measure again after any big EQ change and judge the quiet passages by ear.
Lowering it
- Move closer to the microphone. Halving the distance gains about 6 dB over the room.
- Turn off noise sources and close the door.
- Set preamp gain properly. Recording 20 dB too low and boosting later brings the preamp's hiss up with it.
- High-pass anything that doesn't need lows.
- Cut the gaps between phrases.
- Use noise reduction for what's left, 6 to 12 dB at most.
Quick answers
- What is a good noise floor for vocals?
- −60 dBFS or lower, measured in a gap on the raw track, is clean. −50 dBFS is usable. Above −45 dBFS you will hear it once the vocal is compressed.
- Does compression raise the noise floor?
- Yes. Makeup gain raises everything, noise included. 6 dB of makeup gain raises the noise floor by 6 dB.
Audizer does this when you ask.A Mac DAW with an engineer built in. Say what you want and it makes the edit. Free download.
Get Audizer