Audizer
Clean-up and recording

How to remove mains hum (50 or 60 Hz)

Find the fundamental, 60 Hz in North America or 50 Hz in most other places, and cut it with a very narrow notch. Repeat at the harmonics that are audible, usually the 2nd through 5th. A high-pass filter above the fundamental removes the lowest part on sources that don't need it.

Where to put the notches

Harmonic60 Hz mains50 Hz mains
Fundamental60 Hz50 Hz
2nd120 Hz100 Hz
3rd180 Hz150 Hz
4th240 Hz200 Hz
5th300 Hz250 Hz
7th420 Hz350 Hz

Odd harmonics are usually stronger. Ground-loop hum is mostly the fundamental; rectified power-supply hum is strongest at the 2nd harmonic, 120 or 100 Hz.

Removing it

  1. Confirm the frequency. Look at a spectrum analyser on a silent stretch. Hum shows as thin vertical spikes at even spacing.
  2. High-pass first where you can. On a vocal, a filter at 90 to 100 Hz with an 18 or 24 dB slope takes out the 50 or 60 Hz fundamental completely. On bass and kick you can't do this.
  3. Notch each audible harmonic. Use the narrowest Q your EQ offers, 10 or higher if possible, and cut 12 to 20 dB. A narrow notch removes the tone and very little music.
  4. Stop at the harmonics you can hear. Each extra notch costs a little tone. 3 to 5 is typical.
  5. Use broadband noise reduction for the buzz. When harmonics run up into the kilohertz range, notching them all isn't practical. Noise reduction trained on steady noise handles the upper part.
  6. Listen to the instrument, not the silence. A bass note at B1 is 61.7 Hz. A 60 Hz notch that's too wide will dip that note. Keep the Q tight.

Fix the cause for next time

  • Ground loops. Two pieces of gear connected by audio cables and plugged into different outlets. Power everything in the signal chain from one outlet strip.
  • Unbalanced cables. Use balanced XLR or TRS for anything longer than a couple of metres.
  • Single-coil pickups. Turn the guitar until the hum drops. Moving 90 degrees can cut it dramatically. Keep away from screens, dimmers and transformers.
  • Laptop power supplies. If hum disappears on battery, the charger is the source. A DI box with a ground-lift switch usually cures it.
  • Dimmers and fluorescent lights. Turn them off while recording.

Quick answers

Is hum 50 Hz or 60 Hz?
60 Hz in North America and parts of South America and Asia; 50 Hz in Europe, the UK, Africa, Australia and most of Asia.
What is the difference between hum and buzz?
Hum is the low fundamental and its first harmonics. Buzz is the same interference with strong high harmonics, typical of dimmers and single-coil pickups.

Audizer does this when you ask.A Mac DAW with an engineer built in. Say what you want and it makes the edit. Free download.

Get Audizer

Updated 2026-11-15. Corrections: support@intuzu.com