Audizer
Clean-up and recording

How hot should you record?

Set the preamp so the loudest moments of the performance peak between −12 and −6 dBFS, with the body of the signal averaging around −18 dBFS. That leaves headroom for a surprise and is far above the noise floor of any modern interface.

Why you don't need to record hot

The advice to get as close to 0 as possible comes from tape and from 16-bit converters, where a quiet recording sat near the noise. A 24-bit converter has a theoretical range of 144 dB, and real interfaces deliver about 110 to 120 dB. A signal peaking at −12 dBFS still sits roughly 100 dB above the converter's noise. The noise you'll hear comes from the room and the preamp, and it rises and falls with the gain knob along with the signal.

The cost of recording hot is real. A singer who leans in on the last chorus can jump 10 dB. Digital clipping flattens the top of the waveform and sounds harsh, and no plugin restores what was cut off.

Targets

SourcePeaksWhy
Vocals−12 to −8 dBFSWide dynamic range; singers get louder as takes go on
Acoustic guitar, piano−12 to −8 dBFSSharp transients
Drums, close mics−10 to −6 dBFSVery fast peaks. Watch the snare
DI bass and guitar−12 to −8 dBFSLeave room for hard-picked notes
Synths and line sources−10 to −6 dBFSPredictable level

How to set it

  1. Have the performer play or sing the loudest part of the song, at performance intensity.
  2. Raise the preamp gain until those peaks land around −10 dBFS.
  3. Record a test pass and look at the waveform. It should be clearly visible and nowhere near the top of the track.
  4. If the interface has a clip light, it should never come on. If it flickers, turn down 6 dB.

What −18 dBFS has to do with it

Analog gear is designed around a nominal level, 0 VU, with 18 to 20 dB of room above it. Many interfaces are calibrated so that 0 VU lands at −18 dBFS. Analog-modelled plugins expect that level too: feed a modelled compressor a signal 12 dB hotter and it distorts and compresses far more than its settings suggest. Recording around −18 dBFS average means everything downstream behaves as designed. More in how to gain stage.

If you recorded too quietly

A take that peaks at −30 dBFS is fine to use. Raise its clip gain 15 to 18 dB. You'll bring the preamp and room noise up by the same amount, which matters only if the room was noisy.

Quick answers

Should recording levels be in the yellow or the green?
Mostly green with peaks touching yellow. Never red.
Can clipping be fixed afterwards?
Not properly. Declipping tools guess at the missing waveform and work on light clipping only. Re-record if you can.

Audizer does this when you ask.A Mac DAW with an engineer built in. Say what you want and it makes the edit. Free download.

Get Audizer

Updated 2026-11-15. Corrections: support@intuzu.com