Audizer
Loudness and mastering

True peak vs sample peak

Sample peak is the highest value stored in the file. True peak is the highest level the actual waveform reaches, including the curve between samples, and it can be 1 to 3 dB higher. Set your limiter's ceiling by true peak, at −1 dBTP, so the master doesn't clip when it's played back or converted to a lossy format.

Peaks between the samples

Digital audio stores the waveform's height at regular instants, 44,100 or 48,000 times a second. When a converter turns that back into sound, it draws a smooth curve through those points. The top of the curve doesn't have to land on a sample. It can sit between two of them, higher than both.

A file can therefore have every sample at or below 0 dBFS and still produce a waveform that goes over. Those are inter-sample peaks. A true-peak meter finds them by oversampling, usually 4 times, which fills in the curve between the stored points.

How big the gap gets

MaterialTrue peak above sample peak
Dynamic, unlimited mix0 to 0.3 dB
Typical limited master0.3 to 1 dB
Heavily limited or clipped master1 to 3 dB
Worst-case test signals6 dB or more

Hard limiting and clipping make it worse. They create flat-topped waveforms with sharp corners, and the reconstructed curve overshoots at each corner. Bright, loud masters are the most affected.

Why it matters

Converters. Some playback devices have little headroom above full scale. An inter-sample over can distort in the analog stage.

Lossy encoding. Streaming services convert your WAV to AAC or Ogg Vorbis. Encoding discards information and changes the waveform slightly, and peaks typically rise by 0.5 to 1 dB, more at low bitrates. A master with true peaks at 0 dBTP will clip after encoding.

Sample-rate conversion. Resampling recalculates every sample, and the new ones can land on what used to be an inter-sample peak.

That's the reason for the −1 dBTP guidance. It leaves a decibel for those processes.

Setting it

  1. Use a limiter with a true-peak mode, or one that oversamples. A limiter that only watches sample peaks will hold samples at the ceiling and let the waveform through above it.
  2. Set the ceiling to −1.0 dBTP. For masters louder than about −10 LUFS, consider −1.5 or −2.
  3. Measure the exported file with a true-peak meter. Confirm the maximum is at or under your ceiling.
  4. If the meter reads higher than the ceiling you set, the limiter isn't true-peak aware. Lower its ceiling by the difference.

The standards

True peak is defined alongside loudness in ITU-R BS.1770. EBU R 128, the European broadcast standard, sets a maximum of −1 dBTP. Spotify's guidance is −1 dBTP, or −2 dBTP for masters louder than −14 LUFS.

What it costs

Dropping the ceiling from −0.1 dBFS to −1 dBTP costs you about a decibel of peak level. On a normalised streaming service that costs nothing, since the service sets playback loudness from LUFS anyway.

Quick answers

What does dBTP mean?
Decibels true peak: the peak level of the reconstructed analog waveform relative to digital full scale, estimated by oversampling.
What should my true peak be?
At or below −1 dBTP for streaming. Use −2 dBTP for very loud masters or when you know the file will be encoded at low bitrates.

Audizer does this when you ask.A Mac DAW with an engineer built in. Say what you want and it makes the edit. Free download.

Get Audizer

Updated 2026-11-15. Corrections: support@intuzu.com