Audizer
Loudness and mastering

What LUFS measures

LUFS stands for loudness units relative to full scale. It's a measurement of how loud audio sounds, as opposed to how high its peaks go. Integrated LUFS is the average over a whole song, and it's the figure streaming services use. One loudness unit equals one decibel.

Why peak level wasn't enough

Two tracks can both peak at −1 dBFS and differ in loudness by 10 dB. A solo piano touches −1 on a few notes. A limited rock chorus sits just under −1 the whole time. Peak meters say they're equal. Your ears disagree.

RMS level, an average of signal power, gets closer. It still treats all frequencies alike, and hearing doesn't: we're much more sensitive at 3 kHz than at 60 Hz.

How LUFS is measured

The method is defined in ITU-R BS.1770.

  1. K-weighting. The audio passes through a filter that rolls off the low end and lifts the highs by about 4 dB above 2 kHz. Bass counts for less and upper mids for more, roughly as the ear hears them.
  2. Mean square. The power of each channel is averaged over time and the channels are added.
  3. Gating. For the integrated figure, the song is cut into 400 ms blocks. Blocks below −70 LUFS are dropped. Then blocks more than 10 LU below the average of what's left are dropped as well. Silence and very quiet passages don't pull the number down.

The three readings

ReadingWindowUse
Momentary400 msWatching the loudest instants
Short-term3 secondsComparing sections. How loud is the chorus?
IntegratedWhole programme, gatedThe one number for the song. What services normalise to

Measure integrated loudness from the first note to the last. A reading taken over the loudest chorus alone can be 3 to 4 LU higher than the song's true figure.

Typical values

MaterialIntegrated
Broadcast TV, EBU R 128−23 LUFS
Broadcast TV, US (ATSC A/85)−24 LKFS
Podcasts and spoken word−19 to −16 LUFS
Acoustic, jazz, classical masters−20 to −14 LUFS
Streaming playback level−14 LUFS on most services
Modern pop and rock masters−11 to −8 LUFS
The loudest commercial masters−7 to −5 LUFS
An unmastered mix−24 to −16 LUFS

LUFS and LU

LUFS is the absolute scale. LU is a difference. A master at −10 LUFS is 4 LU louder than one at −14, and a service targeting −14 will turn it down 4 dB.

What LUFS doesn't tell you

  • Whether peaks clip. That's true peak.
  • How dynamic the song is. That's loudness range and crest factor.
  • Whether it sounds good. Two masters at the same LUFS can be clear and punchy or flat and harsh.

The weighting also means bass-heavy music reads lower than it feels. An 808-driven track can measure −10 LUFS and hit harder than a bright rock track at −8.

Quick answers

Is LUFS the same as dB?
A change of 1 LU equals a change of 1 dB. LUFS is an absolute loudness scale that uses frequency weighting and gating, so it tracks perceived loudness better than peak or RMS level.
What is the difference between LUFS and LKFS?
None in practice. They are two names for the same measurement.

Audizer does this when you ask.A Mac DAW with an engineer built in. Say what you want and it makes the edit. Free download.

Get Audizer

Updated 2026-11-15. Corrections: support@intuzu.com