Audizer
Loudness and mastering

Crest factor: what it tells you

Crest factor is peak level minus average (RMS) level, in dB. It tells you how spiky a signal is. A raw multitrack mix typically measures 16 to 20 dB. A finished, punchy master sits around 10 to 14 dB. Below 8 dB the transients have been limited away.

What it measures

A drum hit has a huge peak and little average energy, so its crest factor is high. A sustained organ chord has peaks barely above its average, so its crest factor is low.

SignalCrest factor
Square wave0 dB
Sine wave3 dB
Distorted guitar6 to 10 dB
Heavily limited master6 to 8 dB
Modern pop or rock master8 to 12 dB
Dynamic master12 to 16 dB
Unprocessed mix16 to 20 dB
Solo snare or kick track20 dB or more

Why it's useful

It predicts how much limiting you'll need. Loudness is about average level. Peaks set the ceiling. If the peak is at −1 dBTP and the crest factor is 20 dB, the average is down around −21. To get that mix to −12 LUFS you'd have to shave about 9 dB of peak, which no limiter does gracefully. A mix arriving with a 14 dB crest factor needs 2 or 3.

It shows what processing did. Compression, saturation, clipping and limiting all reduce crest factor. Measuring before and after shows how much dynamics a plugin removed, apart from any level change.

It flags a mix problem early. A crest factor of 20 dB on the mix bus usually means a few drum transients, or a single stray peak, are sticking far out of everything else.

Lowering it well

Do it in stages, a few dB at each, and nothing has to work hard.

  1. On the tracks. Compress or soft-clip kick and snare by 2 to 3 dB. Level the vocal.
  2. On buses. 2 to 4 dB of drum bus compression. Tape-style saturation.
  3. On the mix bus. 1 to 2 dB of compression.
  4. In the limiter. The final 2 to 4 dB.

That takes a 20 dB mix to 12 or 13 with punch intact. Asking the limiter alone for 8 dB gives the same number and flat drums.

PLR, peak to loudness ratio, is true peak minus integrated LUFS. It's the same idea using the loudness scale. A master at −1 dBTP and −10 LUFS has a PLR of 9.

PSR, peak to short-term loudness ratio, is the same over a 3-second window, so it changes through the song.

Because LUFS is frequency-weighted and RMS isn't, a mix's PLR and its RMS-based crest factor differ by a couple of dB. Compare like with like.

Don't chase a number

A low crest factor isn't a goal. The useful question is whether the drums still have impact at the loudness you've chosen. A dense electronic track can sound great at 7 dB. An acoustic trio at 7 dB sounds strangled.

Quick answers

What is a good crest factor for a master?
10 to 14 dB keeps punch on most pop and rock. Under 8 dB is heavily limited. Acoustic and jazz masters often sit at 14 to 18 dB.
Is crest factor the same as dynamic range?
No. Crest factor is peak versus average at a small scale, mostly transients. Dynamic range in the musical sense, quiet sections versus loud ones, is better described by loudness range.

Audizer does this when you ask.A Mac DAW with an engineer built in. Say what you want and it makes the edit. Free download.

Get Audizer

Updated 2026-11-15. Corrections: support@intuzu.com