Audizer
Mixing

How to gain stage a mix

Before you touch a fader, trim each track's clip gain so its average level sits near −18 dBFS, with peaks no higher than about −6 dBFS. Then mix with the faders near unity. Keep the level roughly the same going into and out of every plugin.

What it fixes

Tracks arrive at wildly different levels. A DI bass peaks at −3 dBFS, a room mic at −30. If you mix straight from that, three things go wrong.

Faders end up in the wrong place. A fader has fine resolution near 0 dB and coarse resolution at the bottom. A track that only works at −35 dB can't be nudged by half a decibel.

Plugins misbehave. A compressor's threshold, a saturator's drive and an amp simulator's input all assume a sensible level. Feed a modelled compressor a signal 12 dB hot and it's crushing before you've set anything.

The master clips. Every doubling of tracks adds about 3 dB. Thirty tracks each peaking at −6 dBFS will overload the mix bus.

The steps

  1. Pull every fader to unity and bypass the plugins.
  2. Trim each track at the source. Use clip gain or a trim control ahead of the inserts, not the fader. Aim for an average near −18 dBFS. Drums and other spiky sources can peak higher, up to −6 dBFS, because their average is low.
  3. Play the loudest section and check the master. With everything at unity it should peak between −10 and −6 dBFS. If it's higher, select all tracks and trim them down together.
  4. Now balance with the faders. They should mostly land between −10 and +3 dB.
  5. Match levels through each plugin. After setting a compressor or EQ, adjust its output so bypassing it doesn't change the loudness. That keeps the next plugin's input where it was and makes honest A/B comparison possible.
  6. Check buses. A drum bus fed by ten tracks runs much hotter than any one of them. Trim the bus input if its compressor is being hit too hard.

Targets

MeasureTarget
Track average (RMS)around −18 dBFS
Track loudness−20 to −18 LUFS
Track peaks−12 to −6 dBFS
Mix bus peaks before mastering−6 to −3 dBFS
Faderswithin about 10 dB of unity

Why −18

It's a calibration convention. Analog gear is built around a nominal level called 0 VU, with 18 to 20 dB of clean headroom above it. Many converters map 0 VU to −18 dBFS, and plugin makers who model analog hardware calibrate to the same figure. Working at that level means the modelled gear operates where the real gear did.

The exact number matters less than consistency. If every track sits within a few dB of the same level, every fader, threshold and send behaves predictably.

Quick answers

What level should tracks be at for mixing?
An average around −18 dBFS with peaks between −12 and −6 dBFS is the common target. In loudness terms that is roughly −20 to −18 LUFS per track.
Does gain staging matter in a 32-bit float DAW?
The mixer itself won't clip internally, but plugins with thresholds or analog modelling still respond to level, and the final output still clips. So yes.

Audizer does this when you ask.A Mac DAW with an engineer built in. Say what you want and it makes the edit. Free download.

Get Audizer

Updated 2026-11-15. Corrections: support@intuzu.com