Audizer
Loudness and mastering

How loud should your mix be before mastering?

Export the mix with peaks somewhere between −6 and −3 dBFS, no clipping anywhere, and no limiter or loudness maximiser on the master. The exact peak figure isn't critical. What matters is that the peaks are intact for mastering to work with.

What mastering needs from the mix

Unclipped peaks. A clipped transient can't be restored. If the master bus hits 0 dBFS, pull every fader down together until it doesn't.

No limiter. A limiter on the mix bus has already made the decisions that mastering is supposed to make, and they can't be reversed. If you've been mixing through one to hear how loud the track will go, bypass it for the export.

Room to work. Mastering EQ boosts raise level. A mix peaking at −0.1 dBFS leaves nowhere to go without turning it down first, which is trivial but is one more step.

The −6 dB convention

"Leave 6 dB of headroom" is good advice mainly because it makes clipping unlikely. In a 24-bit file, a mix peaking at −6 dBFS and the same mix peaking at −1 dBFS are identical apart from a gain change of 5 dB. The quieter one's noise floor is still more than 100 dB below the music.

So don't re-export a mix because it peaks at −2.5 instead of −6. Do re-export if it clips or was limited.

Typical numbers for a healthy premaster

MeasureRange
Sample peak−6 to −3 dBFS
Integrated loudness−24 to −16 LUFS
Crest factor14 to 18 dB
Clipped samples0
Master bus processingNone, or the bus compressor and EQ that are part of the sound

What to leave on the master

Keep anything that's part of how the mix sounds: a bus compressor you mixed into, a tone EQ, light saturation. Remove anything that's there for loudness: limiters, maximisers, clippers.

If you're unsure about the bus compressor, export two versions, with and without.

Before you export

  1. Play the loudest section and watch the master's peak meter. Under −3 dBFS.
  2. Check individual tracks and buses for clip indicators. A clipped bus feeding a master with headroom is still clipped.
  3. Listen to the start and end. Leave half a second of silence before the first note, and let the last reverb tail die completely.
  4. Export at the session's sample rate, 24-bit or 32-bit float, as WAV. No dither needed at those depths. See export settings.
  5. Label it clearly with the song, the mix version and the date.

If you're mastering it yourself

The same rules hold. Finish the mix, bounce it, and master from that file or at least in a separate pass. Mixing and mastering in one sitting, with a limiter on from the first minute, hides balance problems until it's too late to hear them.

Quick answers

Do I need exactly −6 dB of headroom for mastering?
No. Any mix that doesn't clip and isn't limited is fine at 24-bit or 32-bit float. −6 to −3 dBFS is a comfortable convention.
What LUFS should a mix be before mastering?
It usually falls between −24 and −16 LUFS integrated. There's no target; it's a result of leaving peaks intact.

Audizer does this when you ask.A Mac DAW with an engineer built in. Say what you want and it makes the edit. Free download.

Get Audizer

Updated 2026-11-15. Corrections: support@intuzu.com