A rough mix in the right order
Gain stage, pull all faders down, then bring tracks up in order of importance: kick, snare, the rest of the kit, bass, lead vocal, then harmony instruments. Set pans, add high-pass filters, and stop. A rough mix is balance. Compression and reverb come after.
Why balance first
Most of what makes a mix work is relative level. If the vocal is 3 dB too quiet, no EQ fixes it. People who start by perfecting the kick in solo spend an hour and still have no mix. Get every track audible and sitting roughly right, and you'll see which problems are real.
The order
- Gain stage. Trim every track to a common working level. See how to gain stage.
- Faders down. Loop the loudest section, usually the last chorus. If the balance works there, verses are easy.
- Kick. Bring it up until it peaks around −10 dBFS on the master. This is your anchor.
- Snare. About as loud as the kick to the ear. On meters it often reads 1 to 2 dB lower.
- Overheads, hats, toms, rooms. Enough overhead to hear cymbals and give the kit air. Toms as loud as the snare when they're hit.
- Bass. Raise it until the kick and bass feel like one instrument. The master should rise about 2 to 3 dB when the bass joins the kick.
- Lead vocal. It should sit just above the snare and be understandable without effort.
- Guitars, keys, pads. Bring them up until you notice them, then pull back 1 to 2 dB. They support.
- Backing vocals and extras. 4 to 8 dB under the lead.
- Pan. Kick, snare, bass and lead vocal in the centre. Double-tracked guitars hard left and right. Everything else spread between.
- High-pass. Filter the lows out of everything except kick and bass. See what to cut.
- Check in mono, quietly. If the vocal and snare are still clear at low volume in mono, the balance is right.
Where the master should land
After step 12 the mix should peak between −6 and −3 dBFS with no limiter. If it's higher, select all the faders and pull them down together.
What's allowed in a rough mix
| Yes | Not yet |
|---|---|
| Levels and pans | Solo-button EQ surgery |
| High-pass filters | Multiband anything |
| One reverb on a send | Automation |
| A compressor on a vocal that jumps around | Mastering limiter |
| Muting parts that clash | Fixing timing and tuning |
Set a timer for 30 minutes. A balance done quickly at low volume is usually better than one laboured over, because you're hearing the song and haven't yet lost perspective.
Then listen away from the desk
Bounce it and play it in the car or on a phone. Write down the three things that bother you most. Those are your real mix tasks.
Quick answers
- What should I mix first, drums or vocals?
- Either works. Starting with drums and bass builds a solid foundation; starting with the vocal guarantees everything else is fitted around the most important part.
- How loud should the kick be in a rough mix?
- Peaking around −10 dBFS on the master with nothing else playing leaves room for the rest of the mix.
Audizer does this when you ask.A Mac DAW with an engineer built in. Say what you want and it makes the edit. Free download.
Get Audizer