Noise gate settings: threshold, attack, hold and release
Set the threshold 3 to 6 dB above the noise in the gaps. Use a fast attack (under 1 ms for drums, 2 to 10 ms for vocals), 20 to 50 ms of hold, and a release long enough to follow the natural decay: 50 to 150 ms on drums, 100 to 300 ms on vocals. Reduce by 10 to 20 dB, not all the way to silence.
The controls
Threshold. The level at which the gate opens. Too low and bleed opens it. Too high and soft notes are cut off or their fronts are clipped.
Attack. How fast it opens. Drums need the fastest setting available or the transient is shaved. A vocal can click if the gate opens instantly on a vowel, so give it a few milliseconds.
Hold. How long the gate stays open after the signal drops below threshold. This is what stops chattering on a decaying note.
Release. How fast it closes. Match it to the source's own decay.
Range or depth. How far the level drops when closed. A range of −10 to −20 dB hides noise and sounds far more natural than full silence, because the room never completely vanishes.
Starting points
| Source | Threshold | Attack | Hold | Release | Range |
|---|---|---|---|---|---|
| Lead vocal | 4 dB above room noise | 2 to 10 ms | 50 ms | 150 to 300 ms | −10 to −15 dB |
| Kick | above snare bleed | 0.1 ms | 20 ms | 80 to 150 ms | −20 dB to full |
| Snare | above hat bleed | 0.1 ms | 30 ms | 100 to 200 ms | −12 to −20 dB |
| Toms | above cymbal wash | 0.1 ms | 50 ms | 200 to 500 ms | −20 dB to full |
| High-gain guitar | above amp hiss | 1 ms | 30 ms | 50 to 100 ms | full |
Gate or expander
A gate is a switch. An expander is the gentle version: below the threshold it turns the signal down by a ratio, 2:1 for example, so something 10 dB under the threshold ends up 20 dB under. Expanders are more forgiving on vocals and acoustic instruments, where levels cross the threshold gradually.
Common problems
- Clipped first syllables. The threshold is too high, or the attack is too slow. In a DAW, editing the gaps out is more reliable than a gate for vocals. See strip silence.
- Snare gate opens on the hi-hat. If your gate has a sidechain filter, focus it around 200 Hz, where the snare is strong and the hat is weak.
- Toms sound choked. Lengthen the release until the tom's ring finishes naturally.
- Noise pumps in and out. Use less range. A 10 dB drop is easier on the ear than on/off.
Quick answers
- What should the threshold be on a noise gate?
- Just above the noise you want to remove. Find the level of the bleed or hiss in a gap and set the threshold 3 to 6 dB higher.
- Why does my gate chatter?
- The signal is hovering around the threshold. Add 20 to 50 ms of hold, lengthen the release, or use hysteresis if the gate has it.
Audizer does this when you ask.A Mac DAW with an engineer built in. Say what you want and it makes the edit. Free download.
Get Audizer