How to use a transient shaper
A transient shaper has two main controls. Attack makes the first few milliseconds of each hit louder or softer. Sustain makes the body and tail after it louder or softer. It needs no threshold, so every hit gets the same treatment whether it was played hard or soft.
How it differs from compression
To add punch with a compressor you use a slow attack so the front of the hit escapes before the gain drops. It works, but only on hits loud enough to cross the threshold. Ghost notes are untouched and the loudest hits get the most effect.
A transient shaper compares a fast-reacting measure of the signal's level with a slower one. Where the fast one runs ahead, there's a transient, and the attack control scales it. Where the slow one is higher, the sound is decaying, and the sustain control scales that. Level doesn't come into it.
Recipes
| Goal | Attack | Sustain |
|---|---|---|
| Kick needs more click and punch | +3 to +6 dB | 0 |
| Snare buried in a dense mix | +3 to +5 dB | 0 to −2 dB |
| Toms ring too long | 0 | −4 to −8 dB |
| Room mics too roomy | 0 | −3 to −6 dB |
| Room mics need to sound bigger | 0 to −2 dB | +4 to +8 dB |
| Acoustic guitar pick noise too sharp | −2 to −4 dB | 0 |
| Bass notes lack definition | +2 to +4 dB | 0 |
| Piano too percussive under a vocal | −2 to −3 dB | +1 dB |
| Drum loop too wet | 0 | −4 to −6 dB |
How to set it
- Loop a section that has both soft and loud hits.
- Turn attack up until the change is obvious, then halve it.
- Do the same with sustain, in whichever direction you need.
- Match the output level to bypass and compare.
- Check peak level. Added attack is added peak.
Where it goes in the chain
Before a compressor, added attack gives the compressor a sharper peak to react to, and some of your boost gets taken back. After a compressor, you can restore attack that compression dulled. For cutting sustain, such as tightening toms, position matters less.
Using it instead of a gate
Negative sustain shortens a drum's ring gradually. A gate chops it. On toms and snares, 6 dB of sustain reduction often gives the cleaner result because nothing opens or closes, and the bleed between hits just gets quieter.
Limits
It can't add attack that isn't in the recording. A kick with no beater click gains thump from attack boost, and no click. Heavy attack boost on full mixes or overheads makes cymbals spit. Keep it to individual drums and percussive parts.
Quick answers
- What is the difference between a transient shaper and a compressor?
- A compressor reacts when the signal crosses a threshold, so quiet and loud hits are treated differently. A transient shaper reacts to the shape of each hit and treats soft and loud ones alike.
- Does a transient shaper increase peak level?
- Yes when you add attack. A few dB of attack boost can raise peaks by the same amount, so check for clipping and follow it with a limiter if needed.
Audizer does this when you ask.A Mac DAW with an engineer built in. Say what you want and it makes the edit. Free download.
Get Audizer