Vocal chain order
Edit and clean the take, tune it, level the phrases, then insert: subtractive EQ, compressor, de-esser, tone EQ, and optional saturation. Reverb and delay go on sends. Each stage works better because of the one before it.
| Stage | Job | Why it sits here |
|---|---|---|
| 1. Clean-up | Strip silence, fades, light noise reduction | Everything later would amplify noise and breaths |
| 2. Tuning | Pitch correction | Pitch detection is most reliable on an unprocessed voice |
| 3. Levelling | Clip gain per phrase | Gives the compressor an even input |
| 4. Subtractive EQ | High-pass, mud and resonance cuts | Stops the compressor reacting to rumble and boom |
| 5. Compressor | 3 to 6 dB of control | Sets the vocal's steady level |
| 6. De-esser | 3 to 6 dB off esses | Compression has just made them louder |
| 7. Tone EQ | Presence and air | Shaping after dynamics, so boosts stay put |
| 8. Saturation, optional | A little harmonic density | Last, at low drive, to taste |
| Sends | Reverb, delay | Parallel, so the dry vocal stays clear |
The reasoning
Order matters most where one process changes what the next one sees.
A compressor responds to whatever is loudest. If the track still has plosive thumps at 60 Hz, the compressor ducks the whole voice every time one hits. Filter first.
Boosting 10 kHz before a compressor works against itself: the compressor hears the brighter signal and turns it down. Boost after, and you get what you dialled in.
Tuning after compression or saturation is asking the pitch detector to read a signal with added harmonics and a raised noise floor. It will make more mistakes.
Variations that are fine
- De-esser before the compressor. Use this when harsh esses are triggering the compressor and causing dips after each one.
- Two compressors. A fast one catching peaks, then a slower one for overall level. Put the de-esser after both.
- A second de-esser on the reverb send. Keeps the reverb from splashing on sibilants.
- No saturation. Most vocals don't need it.
What doesn't work
Reverb as an insert before compression. The compressor raises the reverb tail between words and the vocal sounds like it was recorded in a tunnel. Keep time-based effects on sends, after all the dynamics.
Quick answers
- Should EQ go before or after compression on vocals?
- Both. Cut problems before the compressor so it doesn't react to them, and add brightness after so the compressor doesn't fight the boost.
- Where does pitch correction go in the chain?
- First, on the clean recording, before any EQ, compression or effects.
Audizer does this when you ask.A Mac DAW with an engineer built in. Say what you want and it makes the edit. Free download.
Get Audizer