Vocals
Vocal EQ starting points
High-pass at 80 to 100 Hz. Cut 2 to 4 dB somewhere between 250 and 400 Hz if the vocal is muddy. Add 2 to 3 dB around 3 to 5 kHz for presence and a 2 dB shelf above 10 kHz for air. Make each move only if you hear the problem it fixes.
The map
| Range | What lives there | Typical move |
|---|---|---|
| Below 80 Hz | Rumble, mic-stand thumps, plosives | High-pass, 12 dB/octave |
| 100 to 200 Hz | Chest and body | Leave, or a shelf cut of 1 to 2 dB if recorded very close |
| 200 to 400 Hz | Mud, proximity build-up | Cut 2 to 4 dB, Q around 1.5 |
| 400 to 800 Hz | Boxiness, "small room" sound | Cut 1 to 3 dB if present |
| 800 Hz to 1.5 kHz | Nasal, honky tone | Narrow cut of 2 dB if it's there |
| 2 to 5 kHz | Intelligibility and presence | Boost 1 to 3 dB, or cut if harsh |
| 5 to 9 kHz | Sibilance | Use a de-esser instead of EQ |
| 10 kHz and up | Air and breath | High shelf, +1.5 to 3 dB |
A working method
- High-pass first. Raise the cutoff until the voice starts to thin, then back off 10 or 20 Hz.
- Cut before you boost. Sweep a 6 dB boost with a narrow Q between 200 and 800 Hz. Where the vocal sounds worst, turn the boost into a 2 to 4 dB cut and widen the Q.
- Add presence in the mix, not in solo. Bring up 3 to 5 kHz until the lyrics are easy to follow over the band. If it takes more than 4 dB, something else is masking the vocal there. Turn down guitars or keys in that range instead.
- Air last. A shelf at 10 to 12 kHz makes a vocal sound expensive, and it makes esses and noise louder. Check both afterwards.
An example
In the sample session shown on this site, the EQ on the lead vocal reads: high-pass at 95 Hz, low shelf −1.5 dB at 180 Hz, −3.5 dB at 290 Hz, +2.5 dB at 3.1 kHz, −2 dB at 6.8 kHz and a +2.5 dB shelf at 10 kHz. That's the pattern above: clear the bottom, pull the mud, lift presence, calm the sibilant band, add air.
Things that aren't EQ problems
- A vocal that's dull in the verse and harsh in the chorus needs levelling and compression, or a dynamic process like multiband compression.
- A vocal that disappears on some words needs clip gain.
- A vocal that sounds far away was recorded far away. Presence boosts help a little.
Quick answers
- Where should I high-pass a vocal?
- 80 to 100 Hz for lower voices and 100 to 120 Hz for higher ones, with a 12 dB per octave slope.
- What frequency makes vocals sound muddy?
- Usually 200 to 400 Hz. A 2 to 4 dB cut with a medium-width bell clears it.
Audizer does this when you ask.A Mac DAW with an engineer built in. Say what you want and it makes the edit. Free download.
Get Audizer