Parallel compression
Send the track to a second channel, compress that channel hard (8:1 or more, fast attack, 10 dB or more of reduction), and blend it in underneath the untouched original until the sound gets denser. The peaks come from the dry signal and the body comes from the compressed one.
Why it works
Normal compression turns loud things down. Parallel compression leaves loud things alone and turns quiet things up.
On a loud hit, the dry signal is far louder than the crushed copy, so the copy barely contributes. Between hits, the dry signal has decayed and the crushed copy, with its level held up by compression and makeup gain, fills the gap. The result has the transients of an uncompressed track and the sustain of a heavily compressed one.
Settings
| Source | Ratio | Attack | Release | Reduction on the copy | Blend |
|---|---|---|---|---|---|
| Drum bus | 8:1 to 20:1 | 1 to 5 ms | 50 to 100 ms | 10 to 20 dB | 6 to 12 dB under dry |
| Lead vocal | 6:1 to 10:1 | 2 to 5 ms | 50 to 80 ms | 8 to 12 dB | 8 to 12 dB under dry |
| Bass | 8:1 | 5 to 10 ms | 100 ms | 8 to 12 dB | 6 to 10 dB under dry |
| Whole mix | 2:1 to 4:1 | 10 ms | 100 ms | 4 to 6 dB | 10 to 15 dB under dry |
Setting it up
- Create a bus and send the track or group to it at 0 dB, pre- or post-fader as you prefer.
- Put a compressor on the bus with the settings above. It should sound overcooked on its own.
- Pull the bus fader all the way down.
- With the full mix playing, raise it slowly. Stop when the source sounds thicker and closer.
- Mute and unmute the bus. The difference should be density, with no change in the character of the attack.
- The combined level went up. Pull the dry and parallel faders down together to compensate before judging.
Or use the compressor's mix control on the track itself. Set the compression heavy, then turn the mix down to 20 to 40%.
Shaping the parallel channel
Because the crushed copy is a separate signal, you can treat it. On drums, a boost at 100 Hz and at 8 to 10 kHz on the parallel bus adds weight and sizzle without touching the dry kit. On a vocal, a high-pass at 200 Hz on the copy keeps it from adding mud.
The phase trap
The dry and compressed signals must arrive at exactly the same time. If the compressor on the parallel bus adds latency, such as look-ahead, and the DAW doesn't compensate, the two copies are offset by a few milliseconds and comb-filter. The drums go thin and phasey. If parallel compression makes a track sound smaller, suspect this first. A plugin's own mix knob avoids the issue, since the blend happens inside it.
When to skip it
If the part is already dense, such as distorted guitars or a pad, there's nothing for it to fill in. And if the track's noise floor is high, the crushed copy will bring it up by 10 dB or more.
Quick answers
- What is New York compression?
- Another name for parallel compression on drums: the kit is sent to a bus, compressed very hard, and mixed back in under the dry drums.
- Is a compressor's mix knob the same as parallel compression?
- Yes. At 30% mix you hear 70% uncompressed signal and 30% compressed, which is the same result as a blended parallel bus.
Audizer does this when you ask.A Mac DAW with an engineer built in. Say what you want and it makes the edit. Free download.
Get Audizer